Mounting The Unit - Westermo MCI-211G Manual Del Usuario

Introduction
The MCI-211G Industrial Gigabit Ethernet Converter, conforming IEEE 802.3 10Base-T, 802.3u
100Base-TX and 1000Base-T/SX/LX standard, supports RJ-45 copper to Gigabit fiber conversion using
store and forward technology. The MCI-211G adopts rugged metal case design to operate in harsh
environments (-25~70
to raise an alarm when a remote fault occurs and also adopts one relay output to alarm users if a port
link fails or if the power fails. Alarms can be enabled/ disabled by dip switch. The fiber port supports
SFP socket for several of SFP transceiver to achieve different link distance.
MCI-211G is recommended to be powered by DC 24V with 12~48V range from the 6-pin removable
terminal block.
Package contents Check List
Box contents
MCI-211G
Quick Installation Guide

Mounting the Unit

Din-Rail mount: Mount the din-rail clip screwed
on the rear of MCI-211G on the DIN rail.
Wiring the Power Inputs
1. Insert the positive and negative wires into the
V+ and V- contact on the terminal block connector.
2. Tighten the wire-clamp screws to prevent the
DC wires from being loosened. See Figure-1
Notes: The recommended working voltage
is DC24V (DC12~ 48V)
o
C); It also provides IP-31 standard protection. It features Link Fault Forwarding
MCI-211G
DC1 Alarm DC2
A B
MCI-211G
MCI-211G
Figure-1