Programming An Intercom Call From The Indoor Station To The Smartphone - Urmet 1083/58A Manual De Instalación

1.4. PROGRAMMING AN
INTERCOM CALL FROM
THE INDOOR STATION
TO THE SMARTPHONE
After checking that the call sender device is
correctly confi gured, go to the apartment station to
be programmed as caller.
There are two different programming methods
(check which method is used in the instruction
manual supplied with the product):
A) Programming without picking up the
handset (Vmodo and Miro).
For Vmodo:
1. Hold the button pressed for longer than
5 seconds. The
slowly to indicate that programming mode
is selected.
2. Select Auto-insertion from the smartphone
to the external unit. Go to step 3b.
For Miro:
1. Establish a call from the door unit to the
apartment station.
2. On your smartphone, answer the call and
leave the conversation open.
3. On the apartment station:
a. hold the button
than 5 seconds; the yellow LED will blink
slowly to indicate that programming
mode is selected;
b. Then press the button to be programmed
(e.g. /
Mod. for at least three seconds until the
confi rmation tone is heard.
4. On the smartphone, open the pedestrian
door.
5. On the apartment station:
a. you will hear a confi rmation beep;
b. to quit the programming mode, hold the
key down for more than 5 seconds.
6. Close the conversation or auto-on in
progress on the smartphone.
7. To check the programmed function:
For hands-free models
a. press the button
the programmed button (e.g. )
For models with handset
a. pick up the handset from the apartment
station and press the programmed
button (e.g. or
b. check presence of the call on your
smartphone
answering.
14
button will blink red
pressed for longer
for Mod. Vmodo, /
fi rst and then press
);
and the audio when
B) Programming with handset off-hook (Mod.
Signo).
1. Make a call from the outdoor station to the
indoor station.
2. On your smartphone, answer the call and
leave the conversation open.
3. On the indoor station:
a. hold the door opener button 1 pressed
and lift the handset 2 . A tone coming
from the indoor station will indicate that
programming is in progress.
1
b. now press the button
programmed and wait for a confi rmation
tone from the indoor station.
for
3
4. On your smartphone, open the pedestrian
access door.
5. On the indoor station:
a. a
programming has been successfully
completed;
b. now hook up the handset of the indoor
station - which will beep to confi rm
programming mode quitting.
6. On your smartphone, end the current
conversation.
7. To check the programmed function:
a. lift the handset off the hook at the indoor
station and press the programmed key;
b. check for the presence of the call
on your smartphone and of a voice
feedback when you answer.
beep sound will
2
to be
3
confi rm that
DS1083-105