Kinetec Spectra Manual De Empleo página 44

Use of the hand control
How to define the patient tolerance • At the start of a session
This function, MODULATION Mode is a way to set within the tolerance of a patient at the beginning of a session.
Set up the patient and proceed as below:
Beginning
Switch the unit ON
To select the MODULATION Mode
To select the pain level
( for flexion, for extension)
To set the pain level when reached, immediately press
To start the session with the new movement limits
GB
16
Keys to press
KINETEC
Spectra V01.0
Please wait
Kinetec
30 STOP
Or
WARMUP
30 STOP
MODUL.: use + or -
30 STOP
Or
MODUL.: use + or -
30manual
Continuous press
or
MODUL.: use + or -
30manual
KINETEC
30 run
Display
Check if the hand control is not blocked
(See page 7).
If the Warm Up mode is selected, switch OFF
this mode by pressing on the key
15 90
15 90
The display indicates the keys to be used to
drive the machine, this message is displayed 3
15 90
seconds.
The unit is moving to the selected way.
50 90
It is waiting for you to select new limits.
The new limit of the movement is recorded
50 50
The angle display changes with current
45 50
movement.
Remarks