Connecting To Network - Westermo SDI-880 Guía De Instalación Rápida

Connecting to Network

1. Connecting the Ethernet Ports: Connect one end of an Ethernet cable into an RJ-45 port
SDI-880/SDI-862, while the other end is connected to the attached networking device. All UTP ports
support auto MDI/MDIX function. The Speed LED will turn on for 100M link and turn off for 10Mbps
link, the LNK/ACT LED will turn on for link up and blink for packet transmit and receive. The fiber
ports only support 1 LED for Link and Activity.
2. Connecting the Fiber Ports (SDI-862) : Connect the fiber ports on your SDI-862 to another Fiber
Ethernet device, by following the figure below. Wrong connection will cause the fiber ports not work
properly.
ATTENTION
DIP Switch Settings for Alarm Relay Output
Pin No. # Status
ON
P1 to P8
(Pin1 ~ 8)
Off
ON
P9
Off
This is a Class 1 Laser/LED product.
Don't look into the Laser/LED Beam.
Description
To enable port link down alarm at this port.
To disable port link down alarm at this port.
To enable power failure alarm.
To disable power failure alarm.
RX RX
TX TX
Cable Wiring(SC to SC)
TX A RX B
RX A TX B