Important - Philips InteGrade Guia De Inicio Rapido

Important

Please take the time to read this installation guide before you install this Philips LED product and driver.
The guide contains important information regarding installation and operation.
Warranty
Warranty only applies when the appropriate Philips LED driver and Philips cabling (as described in this guide and leaflets) are used.
Please visit our website www.philips.com/oem or contact your local sales office for more information.
Warnings
• The installation guide does not supersede local or (inter)national regulations for electrical installations.
• This Philips LED product and LED driver must be installed by a professional electrician in accordance with the applicable and
appropriate electrical codes and the instructions provided by Philips.
• This Philips LED product is designed to be connected to a circuit from a class 2 power source (Philips LED power driver) with energy-
limited supply. For maximum system efficacy, load the driver to 90%.
• This is a 24 V DC product. Please ensure proper routing of the cable to avoid cable damage.
• Do not connect this LED product to mains voltages.
• To allow for variance in the installation, it is not recommended to load the power driver beyond 90% of its rated maximum power.
• Before installation, maintenance or cleaning, always first switch off or disconnect the power and follow the appropriate safety
procedures.
• Do not use tape to fix this InteGrade LED product or LED profile in position; please use the appropriate mounting clips.
• Please note that the colors of the wires in existing designs, such as refrigeration systems or cabinets, may differ. The position of the
(original) ballast may also differ.
• Do not make sharp bends with electrical wires.
• For UL region only: CAUTION: To reduce the risk of fire, do not install in a compartment smaller than 11.8 inches (30 cm) by 11.8 inches
(30 cm) by length of luminaire.
• Due to the variety of designs and brands in which the Philips LED products can be installed, you may need to use customized
mounting accessories to fit the specific design you are using. If you require further support, please contact your local Philips sales
organization.
• Use magnets only on steel surface with maximum paint thickness of 50 μ (Microns).
• Philips advises using a zero-crossing/switching solid-state relay to reduce the inrush current peak.
• This product is designed for damp and dry locations only.
Cleaning
• Use a damp cloth and a mild cleaning agent. Do not wipe the LED product with a dirty or very wet dishcloth or towel because they may
leave residue that can damage the LED product.
• Do not use abrasive cleaners, scouring pads, bleach or cleaners containing chlorine because they can scratch and damage the LED
product.
Allowed drivers
LED Power Driver 20W-24V *
LED Power Driver 80W-24V *
LED Power Driver 100W-24V *
LED Power Driver 150W 24VDC 120-240V*
LED Power Driver 240W 24VDC 120-240V*
* The InteGrade LED engine system powered by this driver is Compliant to IEC 60335 standard (Household and similar electrical appliances)
System disposal
We recommend that the module and its components are disposed of in an appropriate way at the end of their (economic) lifetime. The
modules are in effect normal pieces of electronic equipment containing components that are currently not considered to be harmful to
the environment. We therefore recommend that these parts are disposed of as normal electronic waste, in accordance with local
regulations.
2 - 12 Quick Install Guide - Philips InteGrade LED fixture system NB
12nc
929000654006
929001669406
929001669506
929002101980
92900210208
April 2019