Important Safety Instructions; Agency Approvals; Summary Of Operation; Description - BriskHeat SpeedTrace Extreme FFSL81-6 Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

DANGER
A person who has not read and
understood all operating
Instructions is not qualified to
operate this product.
DANGER
•
Do not immerse heater in liquid.
•
Keep volatile or combustible material away from
heater when in use.
•
Use heater only in approved locations.
•
Keep sharp metal objects away from heater.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:
•
Only qualified personnel are allowed to connect
electrical wiring.
•
Disconnect all supply power at the source before
making any power connections.
•
All electrical wiring must follow local electrical
codes.
•
The person who performs the final installation /
wiring must be qualified for this work.
•
The end-user is responsible for providing a
suitable disconnecting device.
•
The end-user is responsible for providing a
suitable electrical protection device. It is highly
recommended that a ground fault circuit breaker is
used.
Failure to observe these warnings may result in personal
injury or damage to the heater.
®
© BriskHeat Corporation. All rights reserved.
SpeedTrace Extreme Self-Regulating
Heating Cable

Agency Approvals

CAUTION
•
Never handle the heating cable while it is in
operation; always disconnect the heating cable
from the power source and allow to cool prior to
handling.
•
Inspect heating cable before use.
•
If spillage of foreign matter onto heater occurs,
disconnect from power source and clean after
heating cable has been allowed to cool.
•
Fasten heating cable to pipes using approved
methods only.
•
Do not repair damaged or faulty heating cable.
•
Do not crush or apply severe physical stress on
heating cable or cord assembly.
•
Unplug heating cable when not in use.
•
Do not use for other applications.
Failure to observe these warnings may result in personal
injury or damage to the heater.
3
WARNING
Read and understand this entire manual before operating this heating cable.

SUMMARY OF OPERATION

®
1. BriskHeat SpeedTrace Extreme Heating Cables are designed for freeze protection on
metal and plastic pipes.
2. Suitable for indoor or outdoor use.
3. Easy-to-install: pre-assembled with power cord and plug. (230V models have bare wire
leads).
4. Safe to overlap and insulate.
5. Automatically adjusts heat output based on surface and ambient temperature.
6. No temperature controller is required.

DESCRIPTION

SpeedTrace Extreme pre-assembled, self-regulating heating cables are designed for commercial
metal and plastic pipe freeze protection.
SpeedTrace Extreme heating cables are available in 6, 12, 24, 50, 75, and 100 foot lengths, and
each comes assembled with a 30-inch power cord and plug. (230V models have bare wire leads).

KIT CONTENTS

1. SpeedTrace Extreme pre-assembled, self-regulating heating cable.
2. Electrical tracing pipe labels.
Additional items required, but not supplied for pipe applications
Adhesive tape, select from fiberglass or aluminum:
•
Fiberglass tape, PSAT36A, 0.5 in wide, 36 yards long.
•
Aluminum tape, AAT260, 2.0 in wide, 60 yards long.
Insulation:
•
INSUL-LOCK DS Flexible Closed Cell Pipe Insulation.
®
© BriskHeat Corporation. All rights reserved.
SpeedTrace Extreme Self-Regulating
Heating Cable
4