How To Install Your Remote Control - Fanimation DISTINCTION D1 Serie Manual Del Usuario

How to Operate Your Ceiling Fan (Continued)
9. If you have encountered an issue during the set up
process, you can follow the below procedure to clean the
memory code of your handheld remote: (Figure 7)
1) Turn the wall switch that controls the power to the fan
to the o position, or the breaker that controls the power
to the fan to the o position.
2) Turn the wall switch that controls the power to the fan
to the on position, or the breaker that controls the power
to the fan to the on position.
3) Press the "SET" button inside of the battery
compartment of the handheld remote control WITHIN 30
seconds of restoring power to the fan.
4) Pressing the "SET" button for 2 seconds will indicate if
the fan is programmed to the remote control in hand.
5) The fan will beep twice and the light will turn on and o
twice, if there is no light, the fan will beep only – this
indicates that the fan has learned the code of the hand-
held you are holding.
6) Pressing the "SET" button for 5 seconds or more will
start the code clearing process. The fan will beep twice,
the light will turn on and o twice if the fan has a light.
7) This will indicate that the fans and handheld remotes
have cleared their memory codes.
8) Please note in order for the memory codes to be
cleared, you must hold the set button for 5 seconds or
longer.

How to Install Your Remote Control

1. Installing Wall Holder: (Figure 1)
Attach wall plate using the two provided screws.
20
SET
Figure 7
Figure 1