PIAA 1100p Serie Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

● When using a commercially supplied lamp bracket, before removing the bolt that is already
installed on the car body, make sure that it is safe to do so.
● The lamp should be mounted in an area sufficient to support its size and weight. Failure to do
so may result in excess vibration leading to shorter bulb life and or physical damage to the
lamp or your vehicle.
● Do not attempt to install the lamp directly to any plastic part of the vehicle body.
  If the lamp needs to be installed on the plastic
reinforcement materials should be placed on both sides of the plastic part.
● When installing, make sure the lamp body, lens and rim are not touching the bumper and
  other plastic parts. Such plastic parts might deform.
● The lamp installation surface should be flat.
● Do not use an Impact wrench when mounting the lamp.
● Over torquing the mounting nut on the base could cause
base failure and void the warranty.
● You must utilize the flat washer and spring washer.
● Torque specifications on the base mounting nut is 9.5ft・lbs (13N・m)
● Torque specifications on the bracket mounting nut is 3.8ft・lbs (5.2N・m)
● The lamp should be tightened to the degree that the lamp body cannot be moved by hand.
● The lamps are designed to be hanging down. It is very important that you make sure that
the "PIAA" etched in the rim reads right side up.
Make sure the installation
position is correct and the
logo will not be upside down.
-5-
PKI-0052
Impact wrench

Publicidad

Tabla de contenido
loading

Tabla de contenido