Connecting The Tv; Cable System And Vhf/Uhf Antenna System - Sony KDL-22BX320 Manual De Instrucciones

Connecting the TV

Cable System or VHF/UHF Antenna System
You can enjoy high-definition and standard-definition digital programming (if available in your
area) along with standard-definition analog programming.
This TV is capable of receiving unscrambled digital programming for both cable (QAM and
8VSB) and external VHF/UHF antenna (ATSC).
Cable or VHF/UHF (or VHF only)
75-ohm coaxial cable
• It is strongly recommended that you connect the CABLE/ANTENNA input using a 75-ohm
coaxial cable to receive optimum picture quality. A 300-ohm twin lead cable can easily be affected
by radio frequency interference, resulting in signal degradation.

Cable System and VHF/UHF Antenna System

Use an optional A-B RF switch (not supplied) to switch between the cable and over-the-air antenna
programming, as indicated below.
Cable
Antenna
• Be sure to set the Signal Type setting to Cable or Antenna found under the Channel settings
for your input signal (page 35).
CABLE/ANTENNA
A/B RF Switch
A
B
Rear of TV
Rear of TV
CABLE/ANTENNA
9