Tabla de contenido
Publicidad
a WARNING: Use only 0.080 inch (2 mm) diameter line.
Other sizes of line will not advance properly and will
result in improper cutting head function or can cause
serious injury.
a WARNING: Do not use other materials such as wire,
string, rope, etc. Wire can break off during cutting and
become a dangerous projectile that can cause serious
injury.
CUTTING METHODS
a WARNING: Use minimum speed and do not crowd
the line when cutting around hard objects (rock, gravel,
fence posts, etc.), which can damage the trimmer
head, become entangled in the line, or be thrown
causing a serious hazard.
The tip of the line does the cutting. You will achieve the
best performance and minimum line wear by not crowding
the line into the cutting area.
The right and wrong ways are shown below.
The line will easily remove grass and weeds from around
tender bark of trees or shrubs and scar fences. To help
avoid damage especially to delicate vegetation or trees
with tender bark, shorten line to 4-5 inches (10-13 cm) and
use at less than full throttle.
For trimming or scalping, use less than full throttle to
increase line life and decrease head wear, especially:
• during light duty cutting.
• near objects around which the line can wrap such as
small posts, trees or fence wire.
For mowing or sweeping, use full throttle for a good clean
job.
TRIMMING
Hold the bottom of the trimmer head about 3 inches (8
cm) above the ground and at an angle. Allow only the tip
of the line to make contact. Do not force trimmer line into
work area.
a WARNING: Disconnect the spark plug before
performing maintenance except for idle speed
adjustments.
HELPFUL TIP
IMPORTANT: Have all repairs other than the
recommended maintenance described in the instruction
manual performed by an authorized service dealer.
If any dealer other than an authorized service dealer
performs work on the product, WEED EATER may not
pay for repairs under warranty. It is your responsibility to
maintain and perform general maintenance.
CHECK FOR LOOSE FASTENERS AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
• Assist Handle Screws
• Debris Shield
• Fuel Cap
CHECK FOR DAMAGED OR WORN PARTS
Contact an authorized service dealer for replacement of
damaged or worn parts.
STOP SWITCH
Ensure STOP switch functions properly by pushing and
holding the switch in the STOP position. Make sure engine
stops. Restart engine and continue.
SCALPING
The scalping technique removes unwanted vegetation
down to the ground.
Hold the bottom of the trimmer head about 3 inches (8 cm)
above the ground and at an angle. Allow the tip of the line
to strike the ground around trees, posts, monuments, etc.
This technique increases line wear.
MOWING
Your trimmer is ideal for mowing in places conventional
lawn mowers cannot reach. In the mowing position, keep
the line parallel to the ground.
Avoid pressing the head into the ground as this can scalp
the ground and damage the tool.
SWEEPING
The fanning action of the rotating line can be used for a
quick and easy clean up. Keep the line parallel to and
above the surfaces being swept and move the tool from
side to side.
MAINTENANCE
FUEL TANK
Discontinue use of unit if fuel tank, fuel cap, and/or fuel
lines shows signs of damage or leaks.
DEBRIS SHIELD
Discontinue use of unit if debris shield is damaged.
INSPECT AND CLEAN UNIT AND LABELS
After each use, inspect complete unit for loose or damaged
parts. Clean the unit and labels using a damp cloth with a
mild detergent.
Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
increases fuel consumption and harmful emissions. Always
clean after every 5 hours of operation.
1.
dirt from falling into the carburetor chamber when the
cover is opened.
2.
a WARNING:
3.
6
3 in (8 cm)
Publicidad
Tabla de contenido
