Reese Towpower 37042 Instrucciones De Instalación página 23

USE THIS HOLE
FOR CENTER
SECTION ASSEMBLY
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly (page 2-3); tighten all fasteners to proper specifications (page 1)
1. Remove existing 14mm hex bolt from the weldnut in the end of frame rail using a 18mm socket.
2. Raise side bracket up to the vehicle frame aligning hole 1 with existing weldnut.
3. Using the removed 14mm hex bolt from step 1, loosely install the 14mm hex bolt, ⅝" flat washer, and ⅝"
lock washer into existing weldnuts in the frame.
4. Place ½" X 2" carriage bolt with ¼" spacer block through existing hole in vehicle frame and through hole 4
in the side bracket.
5. Install ½" flat washer, lock washer, and hex nut onto the ½" X 2 carriage bolt.
6. Repeat steps 1 thru 5 for the other side of the vehicle frame.
7. Install center section per SIDE BRACKET LOCATION 3. (See page 3.)
REFER TO SIDE BRACKET LOCATION INSTRUCTIONS FOR PROPER BOLT TIGHTENING SEQUENCE
VEHICLE FRAME
SIDE BRACKET
BUMPER BRACKET
EXISTING WELDNUT
INSTALLATION W
TOOLS REQUIRED
18 MM, ¾" SOCKET
TORQUE WRENCH
SAFETY GLASSES
½" X 2" CARRIAGE BOLT
¼" SPACER BLOCK
HOLE 4
HOLE 1
½" FLAT WASHER
½" LOCK WASHER
½" HEX NUT
⅝" FLAT WASHER
⅝" LOCK WASHER
14mm HEX BOLT
23