Ariens Zoom 2452 HD Manual Del Propietario - Operador página 18

1
\
1. Service
Position
2. Steering
Levers
4
3. Parking Brake
4. Battery
Figure 6
HYDRAULIC FLUID
WARNING: HYDRAULIC FLUID
can result in severe burns. Fluid
in hydraulic system can penetrate
skin and result in serious injury or
death.
Be sure to stop the engine before
doing any work on hydraulic
parts.
Keep body and hands away from
pin holes or nozzles which expel
hydraulic fluid when under
pressure. Use paper or
cardboard, not hands, to search
for leaks.
Ensure all hydraulic fluid
connections are tight and all
hydraulic hoses and lines are in
good condition before applying
pressure to system.
FOREIGN FLUID INJECTED
INTO BODY can result in
gangrene. Fluid must be
surgically removed within a few
hours by a doctor familiar with
this form of injury.
Check Hydraulic Fluid Level
Check the system with the unit cold and
parked on a flat, level surface.
Then run the unit for about one minute and
recheck the levels.
To Add Hydraulic Fluid:
1. Remove the cap from the expansion
tank.
2. Fill the expansion tank with Mobil 1
Extended Performance 15W50 or
equivalent (Ariens p/n 00057100) until
oil level reaches the cold fill line on the
tank.
3. Install the expansion tank cap and then
purge the system. See Purging the
Hydraulic System on page 19.
The hydraulic fluid should be at the cold
fill line of the expansion tank.
Figure 7
Change Hydraulic Fluid and Filter
NOTE: Change hydraulic fluid and filter after
first 75 hours of operation. Change the
hydraulic oil filter and hydraulic oil every 400
hours. Use Mobil 1 Extended Performance
15W50 Synthetic Oil or equivalent for best
component life (Ariens p/n 00057100).
1. Place container under oil filter to catch
oil.
2. Remove the filter guard and oil filter from
the transaxle.
3. Remove the oil drain plug or fitting from
the inlet port and allow the transaxle to
drain completely.
4. Clean the filter mounting surface and
then lubricate rubber gasket on new oil
filter with clean hydraulic oil.
GB- 18