Ariens Zoom 2452 HD Manual Del Propietario - Operador página 26

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.Install new hydro p ump belt b y
positioning
belt o nsheaves.
Put b elt
onto right hand h ydrostat
sheave last.
6.Replace
long m ower belt o nmower
clutch sheave. See
Replacing Mower
Belts on page 25.
2J
©
1
/
OF1631
1. Hydro Belt
2. Spring
3. Idler
4. Engine
Sheave
5. Right Hand
Hydrostat
6. Left Hand
Hydrostat
7. Clutch
8. Clutch
Anchor
Figure 20
MOWER DECKS
Anti-scalp
Roller
Adjustment
The anti-scalp rollers are set at the factory for
typical mowing height, but can be adjusted for
high or low cutting conditions
(Figure 21).
Anti-Scalp rollers are intended to prevent
lawn scalping, not to control cutting height.
For a very high cutting height, set the anti-
scalp rollers in the lowest position on the
bracket.
For a very low cutting height, set the anti-
scalp rollers in the highest position on the
bracket.
NOTE: There are four anti-scalp rollers on
the outside of the mower deck and four anti-
scalp rollers on the inside of the mower deck.
Make sure all anti-scalp rollers are set at the
same height.
Lowest Cutting
Height
Hig
Cutting
Height
Figure 21
Removing
the Mower
Deck
1. Remove PTO belt (See Replacing
Mower Belts on page 25).
,_
WARNING: AVOID INJURY.
Mower lift arms and mower lift
pedal could cause severe injury if
they are not locked before
removing the mower deck.
ALWAYS lock mower deck lift
before removing the deck.
2. Lock the mower deck in the service
position.
Push the mower lift pedal forward
between cutting height number 4 and
number 5 to align the holes in the deck
lift shaft and the deck lift cover. Insert the
cutting height pin in the holes on the side
of the deck lift cover so it passes all the
way through the deck lift cover and
shaft.
IMPORTANT:
The mower lift arms are not
locked unless the cutting height adjustment
pin passes all the way through both the deck
lift cover and shaft.
NOTE: Support the mower deck on blocks or
jack stands before disconnecting
link chains
from mower lift arms to prevent the deck from
falling.
3. Remove link chains from mower lift
arms. Note hole location on mower lift
arms for replacement.
GB - 26

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Zoom 2660 hd991039991040

Tabla de contenido