Warranty And Remedy, Wire Gauge; Operating Instructions; General; Loading Plates - OMG AccuTrac Manual Del Propietário

Warranty and Remedy
ALL WARRANTIES OF THE PRODUCTS DESCRIBED HEREIN,
EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSES
ARE SPECIFICALLY EXCLUDED, EXCEPT FOR THE FOLLOWING:
OMG Roofing Products will repair or replace, at its sole option,
any tool part which within 90 days after sale by OMG Roofing
Products or its distributors, is found by OMG Roofing Products
to be defective in material or workmanship, normal wear and
tear excluded.
THIS IS THE SOLE WARRANTY OF OMG ROOFING PRODUCTS
AND THE SOLE REMEDY AVAILABLE TO DISTRIBUTOR
OR BUYER.

General

1. Use only with 3" square plates (insulation) and approved
fasteners manufactured by OMG Roofing Products.
2. At the beginning of each day, wipe down the tubes and the
bottom of the ejector plate. Lubricate the linkage and the
plate ejector blade, if needed, then unlatch the tool.
3. Load the plate hold with the proper plates.
4. Make sure the screw gun is in the FORWARD mode and is
NOT in the locked ON position. Connect the tool to the
proper power source.
5. At the end of the day, remove any dust accumulation from
the tubes and the bottom of the ejector blade.
6. Lubricate all moving parts. Excess lubricant will evaporate
overnight.
7. Re-latch the tool and store it in its case.

Loading Plates

1. Push and turn the plate retaining handle counterclockwise
and lift the retaining rod to its extended position.
2. Remove the pre-packaged plates from the box. Align the
notch in the plates with the projection on the back side of
the plate hold.
3. Drop the plates into the hold, slide the retaining rod down,
then push and turn it clockwise to lock the handle in position.

Operating Instructions

OMG ROOFING PRODUCTS
Notice
The AccuTrac tool was designed for use with 3" square plates
(insulation) and approved fasteners manufactured by OMG
Roofing Products. OMG Roofing Products is not responsible
for damage to the tool and/or improper installation as a result
of using fasteners and/or plates other than described above.
Important Note Before Using Tool
Extension cords must be of adequate wire size (AWG or
American Wire Gauge) for safety, to prevent loss of power
and to avoid overheating. To determine the minimum wire
size required, refer to the following chart:
Cord Length
in Feet
Wire Size
(Gauge)

Operating the Tool

1. Drop one screw, point down, into the funnel.
2. Fully compress the AccuTrac to allow a plate to be ejected
from the stack and moved into position for attaching to
the insulation. At this point the screw will be released
and will drop down the feed tube. Allow the tool to fully
extend, then drop another screw into the funnel. It will be
contained at the mouth of the funnel until needed.
3. Lock the screw gun trigger in the ON position. Using the
lock will keep the screw gun running cooler. Push the tool
downward to drive the screw through the insulation until it
contacts the deck. Continue to hold down on the tool until
the plate is fully seated.
4. Allow the tool to retract to its original position. This motion
causes the next plate to be ejected from the stack and
the second screw to drop down the feed tube.
5. Check the plate to make sure it is properly seated and
adjust fastener depth if necessary.
6. Pull the tool back on its wheels, push it to the next plate
application position on the roof and repeat the "tool use"
instructions.
800 . 633 . 3800
WWW.OLYFAST.COM
3
25' 50' 75' 100'
18 16 14 14
125' 150'
12 12