Adjustments; Depth Adjustment - OMG AccuTrac Manual Del Propietário

Adjustments

Depth Adjustment

Over-driving can cause the screw to strip out the metal deck
and not hold. The tool should be adjusted to make the plate
snug so that it does not spin freely on the surface. The plate
should not be so tight as to cause it to deform.
To avoid overdriving, it is suggested that the operator
deliberately start with the adjustment set too loose and
then slowly make adjustments until the desired tightness
is reached.
Adjustments are made using the large ring located
on the upper body tube of the tool. Moving
the ring upwards towards the screw gun
will make the screw deeper (tighter).
Note: If you are unable to make the
plate "snug" through adjusting the
depth adjustment nut, make sure that
the screw gun is in the forward posi-
tion (not reverse).
800 . 633 . 3800
OMG ROOFING PRODUCTS WWW.OLYFAST.COM
4