Delta Q QOSMO Instrucciones Para El Uso página 29

• Lower the lever (Fig. 18).
• Place an empty bowl (0.5 L minimum) above the Coff ee/ Water dispensing
wand (Fig. 15).
• Insert the plug (8 Fig. 1) in the socket.
• Turn the machine ON in the ON / OFF switch (Fig. 13).
• Press the Coff ee/ Water dispensing switch (Fig. 17) until the machine runs
out of descaling solution.
• Turn off the machine (Fig 13.) and remove the plug from the mains (Fig. 9).
• Remove the container of water (Fig. 19) carefully and rinse well.
• Fill the container with 0.5 L of clean water and put it again on the machine (Fig. 16).
• Place an empty bowl (0.5 L minimum) above the Coff ee/ Water dispensing
wand (Fig. 15).
• Turn the machine ON once again (insert the plug (8 Fig. 1) in the socket).
• Press the Coffee/ Water dispensing switch (Fig. 17) until the machine runs out of water.
. Rinse the tank (2) well and dry it before using the machine again.
56
Afc_Paginac¦ºa¦âo_Manual[MODIFICADO]5.indd 56-57 Afc_Paginac¦ºa¦âo_Manual[MODIFICADO]5.indd 56-57
GUIDE FOR SOLVING SOME PROBLEMS
In case there is a working problem, the following simple checks are recommended.
In case the problem is not on the list, or even if it still persists after you carry
out the recommended operation, ring our Client Help Line +800 20 50 20 50
so that we may help you solve the problem.
ERROR OR PROBLEM POSSIBLE CAUSE
• The machine will not • The plug has not been
switch on. correctly connected.
• The machine is not
• The coff ee is cold.
ready.
• The coff ee will not fl ow
• Not enough water in the
out, or it does so very
water-container.
slowly.
• Container for collection
• The capsule gets stuck
of capsules full.
in the capsule-holder
housing.
• Capsule misplaced in
the coff ee extraction site.
• Capsule stuck to the
seal ring (in the capsule
holder housing) after
drawing coff ee.
• Capsule stuck to the
seal ring (in the capsule
holder housing) if we
leave the capsule holder
housing lever closed for a
long time.
INSTRUCTIONS
EN
FOR USE
POSSIBLE SOLUTION
• Check the plugging in
the wall outlet.
• Wait for the light to
indicate that temperature
has reached the set-point.
• Make sure the water
level in the water-con-
tainer is regular, and if
necessary fi ll with mineral
water.
• Remove the container
and empty it.
• Open and close the
capsule holder housing
opening lever.
• Open and close the
capsule holder housing
opening lever.
• Push the capsule so it
falls inside the capsule
collection container.
57
29/09/2010 16:54:27 29/09/2010 16:54:27