Publicidad
Idiomas disponibles
Idiomas disponibles
5 Assembly
Take the table fan out of the package and check the device as well as the scope
of delivery mentioned in the table above. Please contact the vendor if any part is
missing or damaged.
Now place the rear protective cage (5) on the fan unit (1). Make sure that the
handle is facing up. Tighten the protective cage firmly using the mounting nut (2).
Then insert the rotor blade (3) and fasten it using the appropriate mounting nut
(4).
Caution: The mounting nut needs to be tightened counter-clockwise.
Mount the front protective cage (5) onto the rear protective cage. A hole is provid-
ed for the locking screw (6) at the bottom of the two protective cages.
Insert the locking screw (6) through the hole of the front and rear guards (5) and
fasten it using the locking nut (7).
Then connect the four mounting brackets to the side.
Now take the pedestal (8) and assemble it together with the fan unit (1). Finally,
the pedestal (8) is fixed using the mounting screws (9) provided. The table fan is
now ready for use.
6 Usage
Keep the fan in an appropriate location and connect the device to a properly in-
stalled 220-240V AC socket.
By tipping the protective cage, you can now change the angle of inclination accord-
ing to your needs.
Push the pin at the top to enable the oscillation. If you do not want to use the
oscillation function, pull the pin out slightly.
You can select between three different speed levels using the rotary switch on the
pedestal.
21
English
Publicidad
