Cleaning And Maintenance - Sloan XLERATOR EHD-500 Serie Manual De Instalacion Y Uso

OUTSIDE: Loosen dirt and grime by gently washing the cover (including air inlet holes). Use a soft cloth or sponge and a mild
soap or detergent with lukewarm water.
INSIDE: Sloan recommends to inspect and clean the inside of the dryer as required at least once per year, or if performance
diminishes. Heavier usage, or an environment that contains excessive lint, dust or other particles, will require more frequent
cleaning.
Lint on the air inlet, the Pre-Filters (Dryer or HEPA if so equipped), or other internal parts of dryer will reduce efficiency and
shorten the life of the working parts. To clean, shut off power to dryer at service connection. Remove Cover by unscrewing
the 2 Tamper-Proof Bolts from side of Cover with the special Tamper-Proof Wrench provided with each dryer. Use a small,
soft brush to gently clean all parts. If your unit contains a dryer Pre-filter or HEPA Filtration System, unclip the Pre-Filter, rinse
the Pre-Filter with water and dry. Re-install.
DO NOT CLEAN THE HEPA FILTER OR ALLOW IT TO COME INTO CONTACT WITH WATER.
Dryer does not turn on
1. Check power to the unit and connections. Verify dryer is
receiving correct voltage (Check the voltage on dryer tag).
2. Locate and check the RED service LED light next to air
outlet on bottom of dryer for the following conditions:
Light is ON – Place hands under Sensor. If light stays on,
then replace Sensor. If light goes off, check to make sure
wiring is correct. If OK, check wire connecting to Motor. If
both are OK, replace Motor.
Light is OFF – Check for loose, disconnected or improper
wiring (See wiring schematic on blower housing) or replace
Control Assembly.
Light is FLASHING – See error codes in CODE chart
Dryer does not Shut Off
1. May be mounted too close to a counter or object (adjust
Sensor range).
2. Check for loose, disconnected or improper wiring at
Control Assembly (refer to wiring schematic affixed to
blower housing.
3. Replace Control Assembly
ADJUSTING THE HEAT OUTPUT, MOTOR SPEED AND SENSOR RANGE
The dryer is shipped with maximum heat and maximum motor speed. To adjust, turn the corresponding knob
Note: Eco® models have no heating element and are set with heat at minimum.
If problems cannot be resolved with the above troubleshooting steps, please call the Sloan
at 1.888.756.2614 and one of our trained technicians will be happy to assist you.
READ AND SAVE THESE INSTRUCTIONS

CLEANING AND MAINTENANCE

TROUBLESHOOTING
COUNTERCLOCKWISE to reduce. H = HEAT M = MOTOR R = RANGE
Dryer blows only cold air (non-ECO dryers)
1. Check heat setting on control.
2. Check for loose connections to Heating Element.
3. Replace Heating Element.
Dryer does not Always turn on, or turns on by itself
1. May be mounted too close to counter or object (adjust
Sensor range).
2. Check for foreign material on Optical Sensor next to Air
Outlet.
3. Check for loose wires on Control Assembly.
4. Replace Control Assembly.
Dryer has loss of air volume
1. Check motor speed setting (Labeled "M") on control. Turn
clockwise to increase.
2. Check for slow running Motor or burning smell. If so,
replace Motor.
3. Check Pre-Filter for lint buildup. Clean by removing
Pre-Filter and rinse in warm water then dry Pre-Filter
before reinstalling.
4. Check for any cracks in plastic housing.
3