TECNO R-evolution Instruction manual
ByTecnoplus
s.r.l.
CENTRAL VACUUM SYSTEMS
11 USE OF THE VACUUM CLEANER
When the R-EVOLUTION vacuum cleaner is connected to the power supply, it can be started every time a
fl exible hose is plugged into any of the suction sockets in the different rooms.
The vacuum cleaning is started thanks to an electrical contact assembled directly in the socket which, once
activated, allows the start of the suction motor of the vacuum cleaning unit.
The specifi cally-designed electronics applied to Tecno R-EVOLUTION vacuum cleaners is based on a so-
phisticated software designed exclusively for Sistem Air, which alerts the operator, by means of a dedicated
messaging package, when routine maintenance should be carried out.
Such maintenance involves the dust bin to be emptied (confi guration 1) or the microfi ber bag to be replaced
(confi guration 2) and the fi lter cartridge to be regularly cleaned.
11.1 Switching on the vacuum cleaner
11.2 Using the vacuum cleaner
Insert the other end of the fl exible hose in the
suction socket on the wall. This will switch on
the system suction motors thanks to an elec-
tric signal in the suction socket.
Once you have fi nished cleaning, remove the fl exible hose from the suction socket by gently
accompanying the closing fl ap until it reaches its housing. If the fl ap is left to close by itself, it
will violently hit the suction socket because the suction system is still working and the vacuum
will pull the fl ap powerfully against the suction frame.
The vacuum cleaner is programmed to take a few seconds before switching off to ensure that
the suction action has been completed throughout the pipe network.
30
Press the switch-on button. A warning
1
light will appear to indicate that the ap-
pliance is connected to the power supply.
Fix the cleaning accessory most suitable for the
1
desired task, to the grip handle of the fl exible
hose. Select the accessories according to the
area to be cleaned, the type of dirt, etc.
2
21/01/16 Rev:3.0.0