Figure 5-17: Wireless Network Access; Figure 5-18: Mac Address Filter List; Figure 5-19: Wireless Client Mac List - Cisco Systems Linksys WAG200G Guia Del Usuario

Wireless-G ADSL Home Gateway
The Wireless Access Tab
Wireless Network Access
Wireless Network Access. Select Allow All you want all computers to have access to the wireless network. To
restrict access to the network, select Restrict Access, and then select Prevent to block access for the
designated computers or Permit only to permit access for the designated computers. Click the Edit MAC
Address Access List button, and the Mac Address Filter List screen will appear.
Enter the MAC addresses of the computers you want to designate. To see a list of MAC addresses for wireless
computers or clients, click the Wireless Client MAC List button.
The Wireless Client MAC List screen will list computers, their IP addresses, and their MAC addresses. Click the

Figure 5-17: Wireless Network Access

Refresh button to get the most up-to-date information. Click the Enable MAC Filter checkbox To add a specific
computer to the Mac Address Filter List, click the Enable MAC Filter checkbox and then the Update Filter List
button. Click the Close button to return to the Wireless Client MAC List screen.
On the Wireless Client MAC List screen, click the Save Settings button to save this list, or click the Cancel
Changes button to remove your entries.
When finished making your changes on this tab, click the Save Settings button to save these changes, or click
the Cancel Changes button to undo your changes.

Figure 5-18: MAC Address Filter List

Figure 5-19: Wireless Client MAC List

Chapter 5: Configuring the Wireless-G ADSL Home Gateway 24
The Wireless Tab