Battery Installation - Hobbytech KN-KT2S Manual De Instrucciones

EVEN IF THIS CAR IS A READY TO RUN KIT, YOU STILL HAVE SOME LITTLE THINGS TO DO TO FAMILIARIZE WITH
YOUR PRODUCT. PLEASE FOLLOW THESE STEPS.

BATTERY INSTALLATION

Supplied with 4 x 1.5V AA Batteries,
KT2S can be operated a few hours.
Installation: ❶ Remove the battery
compartment cover as shown below.
INSTALL THE RECEIVER BATTERY
A
A
Remove the 2pcs receiver box clips from the cover of the receiver box.
B
Install the battery case in the receiver box properly and connect the red plug.
You can close the receiver box cover.
BIND
A
You must check the signal of transmitter and receiver before
you operating it at first.
Make sure TH Trim is on neutral
- TURN OFF THE TRANSMITTER AND RECEIVER -
A
Turn on the switch of the battery case
B
Press and Hold the BIND button on the receiver
.
Release the BIND button when the LED flashes green.
While the green LED flashes, press the BIND button to select the
frame rate.
- Faster flashes= high frame rate (7ms), for digital servo
- Slower flashes= low frame rate (15ms), for analog servo
C
Press and Hold the BIND key of the Transmitter (1), and then
turn on the Transmitter (2), the Transmitter will communicate with
the receiver.
When the receiver LED is solid on, the pairing process is done, and the receiver is paired with the transmitter.
❷ Install the batteries observing
the polarity marked on battery
compartment.
Place model on a block to prevent wheels from touching the ground
❸ Then reinstall the battery
compartment cover as the
Picture shown below.
B
B
(2)
(1)
C
CAUTION :
Do not dispose of batteries in fire, short their terminals,
apply heat to them or disassemble them. .
Used batteries: Please dispose of used batteries properly,
following any local regulations.
Battery distributors are required by law to take back spent
batteries; they must not be thrown away as household
waste.
5