Hobbytech KN-KT2S Manual De Instrucciones página 9

FILLING UP THE FUEL TANK
A
Put some fuel in your fuel bottle
PRIME AND STARTING THE ENGINE
A
Use the proper way to charge your glow starter
A
Put your finger over the exhaust and pull the pull start
until you see fuel enter in the carburator
IMPORTANT - ENGINE INSTRUCTIONS
SAFETY
❶ The engine is not a toy. Its power mights injure you, please use it carefully. Owners have responsibility for your safety when operating to use your motor
❷ It is advisable to ask a competent person during first running
❸ Check if the engine installed correctly in the remote car.
GLOW PLUG ( )
not included
Install a plug suitable for the engine. The compatibility of glow plug may have a marked effect on performance and reliability. Particulary in the case of very high
performance engines, glow plug must be regarded as expendable. However, plug life can be extended and engine performance maintained by careful use.
FIRST RUNNING
This engine is of high technology, if you are not sure how to maintain or repair your engine, you must ask a competent person. A running in period is necessary
for your engine. The proper running in of your engine determines its eventual performance and life. During the running in period, it is advisable to use fuel
with more oil content. The carburator had a basic setting before turning out from our factory. But we recommended to loosen the main needle (3) (around
one turn) before the running in procedure.
During the running in period, it is advisable to use your engine at 50-75% of its performance, during 1 or 1,5 litre.
During the running-in period the engine must always have a good and constant idle and have plenty of smoke and excessive fuel coming out of the stinger.
ATTENTION ! The proper running in of your engine determines its eventual performance and life time, you can shorten the life time and performance
dramatically, and you can also permanently damage the engine.
ADVISE TO MAINTAIN
❶ A properly maintained air filter is essential to the life and performance of every nitro engine. Never run your engine without an air filter or properly air filter
because dust and dirt will enter inside the engine and irreversibly damage and shorten its life cycle.
❷ Clean the outside of the engine with petrol product only. Never clean the engine with water.
❸ Check regulary for different leaks engine
B
Fill up the fuel tank untill the top
B
B
Clamp the glowstarter over the glow plug and pull the
pullstarter with short quick pulse
Engine starts! Let's have some fun...
(1) Carburator Body
(2) Throttle with throttle boot
(3) Main needle
(4) Throttle stop adjustement screw
(5) Throttle needle
C
(2)
(1)
(5)
(3)
(4)
9