Operating Instructions - Dyna-Glo DGA550SSN Manual De Instrucciones

OPERATING INSTRUCTIONS

Lighting Instructions (for all burners, including side burner and rotisserie burner)
Before First Use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid
closed and the control knob in the highest position. This will clean the internal parts by burning off any
residue and odor from the manufacturing process.
Important: If your grill is equipped with a rotisserie burner, only that burner should be used for
cooking when the rotisserie is mounted and in operation. The main burners on the grill must be
turned O OFF when the rotisserie burner is in use.
Important: DO NOT use the rotisserie burner and the main burner at the same time while using the
rotisserie. DO NOT use side burners and the rotisserie simultaneously.
DO NOT lean over grill when lighting. Read instructions before lighting.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF the
manual shutoff valve and then TURN OFF the control knobs.
Read instructions before lighting.
1. Check that the control knobs are in the O OFF position.
2. Open lid during lighting.
3. Open manual shutoff valve fully.
4. Push igniter down 3 to 4 seconds while turning the desired control knob to the
burner should ignite.
NOTE: When lighting the rotisserie burner, the control knob must be pushed in and turned to the
high position. Push igniter down 3 to 4 seconds while continuing to depress the rotisserie burner
control knob in the
control knob for an additional 30 seconds. The rotisserie burner should then stay lit.
If ignition of any burner does not take place within 5 seconds, immediately turn the control knob to
the O OFF position. Wait 5 minutes and repeat step 4 above or refer to match lighting instructions in
manual.
5. Repeat Step 4 above to ignite all other burners.
WARNING
CAUTION
high position. Once the rotisserie burner has ignited, continue to depress the
19
high position. The