Filling The Water Reservoir; Switching On - melitta SOLO Manual Del Usuario

Filling the water reservoir

• Flip up the lid of the water reservoir (Fig. A, no. ) and pull the water
reservoir up and out of the appliance.
• Fill the water reservoir with fresh water to the Max. mark and reinsert it in
the appliance.
Note
If the water reservoir runs empty during an operating process (e. g. during
the coffee dispensing process), the symbol for the water reservoir will be
illuminated. the current operating process will be concluded and the water
reservoir must be filled before starting a new process.

Switching on

Caution!
Only switch on the appliance without the claris
the water tank is full.
–
Only insert the claris
the appliance.
–
Fill the water tank to the max. mark with fresh water before switching
on the appliance.
•
Place a bowl under the outlet.
•
Press the on / off button
→
the standby symbol
After heating up water will run out of the outlet and into the bowl. subse-
quently the standby symbol
the device is ready for operation.
Note
When starting up the appliance for the first time air and water from the
interior of the appliance escape into the drip tray.
Heft_Solo_EU.indd 47
®
water filter into the water tank after switching on
®
to switch the appliance on.
is flashing. The device heats up.
and the bean symbols
water filter and when
are illuminated.

09.07.2009 15:47:28