Using The Device - Verathon GlideScope Go Manual De Funcionamiento Y Mantenimiento

USING THE DEVICE

Prior to using the device, complete the instructions in the chapter
PROCEDURE 1. PREPARE THE SYSTEM
Please read the
following task.
1. Ensure that each GlideScope system component has been properly cleaned or
disinfected according to the guidance provided in the
page 266.
2. Based on a clinical assessment of the patient and the experience and judgment of
the clinician, select the GlideScope video laryngoscope that is appropriate for the
patient.
3. Attach the video laryngoscope to the monitor per
page 262.
PROCEDURE 2. PERFORM AN INTUBATION
Please read the
following task.
To perform an intubation, Verathon recommends using the GlideScope 4‑Step Technique
as outlined in this procedure. Each step begins with where the user should be looking to
complete that action. Prior to beginning this procedure, verify that the monitor is receiving
an accurate image from the video laryngoscope.
1. Look in the Mouth: With the video laryngoscope in your left hand, introduce it
along the midline of the oropharynx.
2. Look at the Screen: Identify the epiglottis, and then manipulate the blade in
order to obtain the best glottic view.
Look in the Mouth: Carefully guide the distal tip of the tube into position towards
3.
the tip of the laryngoscope.
4. Look at the Screen: Complete the intubation, gently rotating or angling the tube as
needed to redirect it.
264
0900‑4788 REV‑10
Hoiatused ja ettevaatusabinõud
Hoiatused ja ettevaatusabinõud
Setting Up the
section before performing the
Reprocessing
Attach the Blade or Baton
section before performing the
System.
chapter on
on