Occupancy Sensor Setup - Lutron GRAFIK Eye QS Serie Guía Rápido De Instalación Y Funcionamiento

Occupancy Sensor Setup

Associating wireless occupancy sensors and GRAFIK Eye
(for wireless enabled units only):
1. Make sure the wireless mode of the GRAFIK Eye
Main menu
unit is "Enabled".
Zone Setup
2. Enter programming mode.
Sensor Setup 3. Use the Master buttons to highlight "Sensor setup" and press
the OK button to accept.
4. Use the Master buttons to highlight "Add wireless sensors" and
Sensor Setup
press the OK button to accept.
5. Press and hold the "Lights Off" button ( on some sensors) on
Add wireless sensors
the occupancy sensor for 6 seconds. The lens will start flashing
Daylight
and the info screen on the GRAFIK Eye
will display the sensor's serial number.
6. Press the OK button on the GRAFIK Eye
Add wireless sensors
screen will confirm that the sensor has been assigned.
(To disassociate a wireless occupancy sensor from the GRAFIK
Initiate association
Eye
of sensors ®
sensor install guide to return the sensor to its "out-of-box"
functionality. Doing so will remove its programming from the
GRAFIK Eye
Occupancy
7. Repeat the above steps for all desired sensors.
8. Exit programming mode.
xxxx-xxxx
Associating wireless occupancy sensors through
Press OK to Save
QS Sensor Modules (QSM):
1. Press and hold the Program button on the QSM for 3 seconds
to enter programming mode. There will be 1 audible beep
and the Status LED will begin flashing. The info screen on the
Saved
*Assigned*
GRAFIK Eye
programming mode.
2. Press and hold the "Lights Off" button ( on some sensors) on
the occupancy sensor for 6 seconds. There will be 3 audible
beeps from the QSM to verify association.
3. Press and hold the Program button on the QSM for 3 seconds
to exit programming mode.
Note: The wireless signal has a range of 30 ft (9 m) through
®
1 9
QS control unit, Refer to the Radio Powr Savr
QS control unit.)
®
QS control unit will display that the QSM is in
®
standard construction or 60 ft (18 m) line of sight.
For additional information, see the complete installation and operation guide at www.lutron.com/qs
QS Wireless control units
®
2 10 3 11 4 12 5 13 6 14 7
QS control
®
QS Wireless control unit
®
QS control unit. A
®
occupancy
TM
GRAFIK Eye QS Control Unit Quick Installation and Operation Guide 15
®
15 8 16
9-16
1-8
OK
Radio Powr Savr
TM
Occupancy Sensors
QS Sensor Module (QSM)
Master
buttons
OK
button
Timeclock
(back) button
Press and hold
"Lights Off" or
button to associate/
disassociate
Program button