Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step 7: Mount Integral Blower or
Outlet Duct Transition for Remote or
Inline Blower
Integral Blower (see Figures 9 and 11 for
further detail):
Y A. Attach blower in front of round ex-
haust outlet with 4-6 (depending on con-
figuration) #8 sheetmetal screws.
Y B. Feed cord from blower through strain
relief.
Y C. Secure strain relief with screws.
Y D. Attach strain relief to downdraft near
junction box.
Y E. Connect cord to downdraft at 6 pin
connector.
Y F. Connect blower to ductwork.
Internal Blower
Fig. 9 – Internal Blower
Step 7: Mount Integral Blower or
Outlet Duct Transition for Remote
Blower
Integral Blower VTN600CV2C (see Figures
10 and 12 for further detail):
Y G. Place the cooktop in countertop ope-
ning with the rear edge of cooktop over-
lapping the front edge of the vent. Make
sure rear edge of cooktop does not bind
against front of snorkel. Follow the ma-
nufacturer's installation Instructions for
installing gasket strips, protective heat
tape (if required), securing the cooktop
to the countertop and making the cook-
top electrical and/or gas connections.
Note: Check boxes as tasks are completed.
Strain Relief
6 Pin
Connector
9
Publicidad
Tabla de contenido
