General Information - EXIT TIGGY junior Manual Do Usuário

4.0 General Information

• Self-securing nuts and screws are suitable only for one time setting-up, and
must be replaced after breakdown of the trampoline and/or safetynet.
• The safetynet has a limited durability, replace after 2 years of use.
• It is recommended to place the trampolines on a flat and level surface with at
least 3 m distance to other superstructures, or barriers, e.g. fence, garage,
house, tree branches, washing lines, or electrical cables.
• The trampoline shall not be placed over hard surfaces like asphalt, concrete etc.
• Exchange defective parts according to the supplier's recommendation.
• Changes to the trampoline (e.g. addition of an accessory) must be done accord-
ing to the supplier's instruction.
5.0 Trampoline Assembly
STEP BY STEP CONSTRUCTION
Only assemble by adult.
To assemble this trampoline all you need is our special spring loading tool provided
with this product. During periods of non-use, this trampoline can be easily disas-
sembled and stored. Please read the assembly instructions before beginning to
assemble the product.
Please refer to the table for part descriptions and numbers. The assembly instruc-
tion use these descriptions and numbers as reference .
Make sure you have all parts listed. If you are missing any parts, please contact
place of purchase.
Please use gloves to protect your hands from pinch points during assembly.
When you are ready to start, make sure that you have plenty of space and a
clean dry area for assembly.
You can find the assembly steps in chapter 5.0 (page 124-134)
MTR-10115-V03
21