Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MASTER FEATURES

10.
MASTER LEVEL CONTROL
Controls the overall volume level of the system.
11.
MASTER REVERB CONTROL
Controls the amount of reverb that will be heard in the main mix.
12.
MASTER EQUALIZATION
Provides ±15 dB equalization at each center frequency. EQ boost is obtained by moving a
particular EQ band's control above the "0" position. EQ cut is obtained by moving a particular
EQ band's control below the "0" position. The following list describes each EQ control and its
center frequency.
Low - shelving type - 80 Hz
Mid - peak type - 1 kHz
High - shelving type - 10 kHz
OPERATION NOTE: This equalizer is designed to provide room equalization, feedback
control and system tone control. No amount of equalization will correct the response curve
of a poor loudspeaker. Always begin with all controls in the "0" position and avoid excessively
cutting large segments of the audio passband, which would limit the system's dynamic range.
13.
MAIN OUTPUT
1/4" unbalanced output that can be used as a source for an external amplifier/speaker
system feed to other mixers or a tape deck.
14.
REVERB/AUX OUTPUT
Plugging into this mono (TS) 1/4" output allows you to utilize external effects devices. In order
to return the signal from the external effects unit, use the Aux Input (15). Simply turn the
Reverb Master down to defeat the Internal Reverb if desired.
15.
AUX INPUT
Use this mono 1/4"(TS) input to insert a line-level signal into the main mix. This signal can
originate from a variety of sources including instrument/mic preamps, external effects
(see #14), and even an additional sub mixer. This input bypasses the reverb and can be
controlled by the Master EQ and Level.
16.
REVERB FOOTSWITCH
Provided for connection of the optional remote footswitch (5100). The footswitch is used to
activate/defeat the reverb.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido