Setting Up The Videolink; Permanent Attachment And Shrink Tube Heating - Luda Elektronik HorseCam Manual Del Usuario

10. Setting up the videoLink

1. Connect the 5m antenna
cable to the receiving
part of the videoLink.
2. Attach the square videoLink antenna to the
transmitting part of the videoLink.
3. Connect the videoLink to a power
source using the 5V power
adaptor.
4. The camera is preset to send
on channel 4. Set the videoLink to
receive on the same channel as the
camera is sending on.
5. We recommend to set the transmitting
channel of the videoLink to 1.
Choose the same channel on
your LCD monitor.
INfOrMAtION
The videoLink receives the weakened signal and transmits it again with increased
strength. This way you will receive a stable and interference free picture inside
your home.

11. Permanent attachment and shrink tube heating

1. Check the picture quality in your home using the LCD-
monitor.
2. When satisfied, mount the A300-antennas permanently
and heat the shrink tube over the antenna connection.
Channel 1
Channel 4
- 38 -
A V
D C
5V