Test Strip - Fora D10 Manual Del Usario

Test Strip

Front Back
The front side of the
test strip should face
up when inserting
the test strip.
The FORA D10 monitor should only be used with FORA D10 Test Strips.
Using other test strips with this meter can produce inaccurate results.
ATTENTION:
Test results might be wrong if the contact
bar is not fully inserted into the test slot.
NOTE
Absorbent Hole
1
Apply a drop of blood here.
The blood will be
automatically absorbed.
Confirmation Window
2
This is where you confirm if
enough blood has been
applied to the absorbent
hole in the strip.
Test Strip Handle
3
Hold this part to insert the
test strip into the slot.
Contact Bars
4
Insert this end of the test
strip into the meter. Push
it in firmly until it will go no
further.
17