Measuring Procedure; Discontinuing A Measurement; Memory-Recall Of Measurements; Reading Memory Record - ABOX U80H Manual De Instrucciones

EN
Proper use of the unit

Measuring Procedure:

After the cuff has been appropriately positioned, the measurement can begin:
1. Press the START/STOP button, all symbols appear on
the display, then the pump begins to inflate the cuff, the
rising pressure in the cuff is shown on the display.
2. After the suitable pressure has been reached, the pump
stops and the pressure gradually falls. The cuff pressure
is displayed. In case that the inflation is not sufficient, the
device automatically re-inflates to a higher pressure.
3. When the device detects the signal, the heart symbol
on the display starts to flash.
4. When the measurement has been completed, the
systolic, diastolic and pulse rate will appear on the display.
5. The measurement readings remain on the display
until you switch off the device. If no button is pressed for
a period of 3 minutes, the device switches off itself in
order to save the power.

Discontinuing a measurement

if it is necessary to interrupt a blood pressure measurement for any reason
(eg.the patient feels unwell)the START/STOP button can be pressed at any
time. The device immediately decrease the cuff pressure automatically.

Memory-recall of measurements

This blood pressure monitor automatically stores 2x90 sets measurement
value, the oldest record will be replaced by the latest measurement value
when more than 90 sets each user.
Read memory record
Press the button MEM when power off, the latest 3 times average value will
be shown, press the button MEM again, the last measurement value will be
shown, as well as subsequent measurement can be displayed one after the
other by pressing the butting MEM each time.
13