Ditel SYROS SY24 Manual De Instrucciones página 19

SY48 – SY49 – SY96
Standby mode
To perform standby operation, set "STby" as ON in the 1st block parameter.
Operation mode
When the SV lamp is lit, the set value
.
(SV) is displayed at the lower line
The set value (SV) can be changed.
Parameters setting mode
Press the for 2 seconds
3 Shift to operation condition
Operation mode
Parameter setting procedure:
1 Select a parameter you want
to set by pressing the
2-1 Press the key to allow the
parameter to change (under the
changing conditions, the parameter
flickers).
2-2 Press the or key to change
the parameter set value.
2-3 After the parameter has been
changed, press the key for
registration.
3 To shift to Operation/Standby
press the key for 2 seconds
Note: If the upper display (PV) comes off (or kept distinguished), make the setting once again by adding 64 to the set value of parameter DP13.
1
Change of set value (SV)
2
Shift to the 1st, 2nd and 3rd block parameter
To shift to the other blocks, press the key
Pressing time
About 1 sec pressing
About 3 sec pressing
About 5 sec pressing
1 Parameter selection
or
Parameter search
Press The Press The
After the data setting, the data are registered automatically in 3 seconds.
Depending on the pressing time of
Shifting block
1st block
2nd block
3rd block
2 Parameter settings
Press the
once
parameter shift mode
By repeating the same procedure, the parameters can be
displayed according to the parameter list shown in "5.
Setting methods of temperature and parameters."
18
Switching by 1st block
STby settings
key, you can select the block to shift.
Switching by
the key
Parameter change
Increases parameter set value
Decreases parameter set value
Register parameter set value, returning to the
1