A Dvanced O Ption; Usb Memory - Triton Blue Discovery 2048 Manual De Usuario

c
onEct
• When a chase is added to run, it will connect automatically.
• If the current connected chase is not the one that you want to connect, you can press <Connect> then <Playback>
to connect.
• If you don't want to connect any chases, then, you can press <Connect> twice to clear all the connections.
• Once the chase are connected, they can be controlled with <Stop>, <Go+> and <Go->. <Go+> and <Go-> are to
control the playback direction. To store the running speed, press <Playback Parameters> then <B>[Save Speed &
Dir].
• When a new chase is connected, you can use <Wheel A> to control the global speed and <Wheel B> to control
the global slope if the current Programmer is empty; But, if the current Programmer is with some data, then, you can
press <Connect> then <E>[Change Wh A/B Mode] to switch to the wheel mode, so that you will be able to control the
time of the scene. The time under the control of <Wheel A> and <Wheel B> is temporary time; To save the time, press
<Playback Parameters> then <B> [Save Speed & Dir]. To restore the previous speed, press <Connect> then <E> to
clear the temporary time. One the speed is save, it cannot be restored.
A o
dvAncEd ption
Each chase has options which can be set to affect the way it runs. Press <P.b. Par>. You need to have a chase "connec-
ted", or the button will not do anything. The options you set are individual for each chase.
The options are:
A - [Save Speed] – saves the current speed of the chase (set using the wheel A).
B - [Save Direction] – save the direction of the chase.
C - [Loop Playback/Bounce/Stop on final step] - makes the chase stop on the final step. If the final step is a blackout,
the chase will appear to turn itself off, so you can just press Go whenever you want to make it happen again.
D - [Skip Time Options] - Allows you to skip the first wait and/or fade of a chase. You often want to do this so the chase
starts as soon as you raise the fader. (Press the button to cycle through options)...
- Skip first wait time (The wait time is missed when the chase is first turned on)
- Skip first wait and fade time (Both wait and fade times are missed when the chase is first turned on)
Wait and Fade for all steps
s
etuP
M usb
AnAgE MEMory
At first menu, press <Setup> button, then press <A> - "U-Disk". Then you can select "Save Data" or "Read Data". In
"Save Data" Menu, use Wheel V to change character, up and down to move the curse. Then press Enter to save.
W
ipE dAtA
At first menu, press <Setup> button, then press <B> to wipe all the data or only the playback data off the controller.
s
ElEct lAnguAgE
Press <Setup>. The LCD will show "English/Chinese". Press the desire soft key by the LCD to select your language.
M
AnAgEr librAry
At first menu, press <Setup> button, then press <D> to delete or update the fixture library.
28
User manual | Discovery 2048 Triton Blue | Rev. January.2016 | www.triton-blue.com