Fitting The Battery; Control Panel And Display; Basic Unctions - Derby cycle Impuls 2.0 ergo Instrucciones De Empleo

Damaged batteries may not be charged, and
urther use is not permitted.
The battery may heat up during charging. A maxi-
mum temperature of 45°C may be reached. If the
battery becomes any warmer than this, suspend
the charging process immediately.
4.4

Fitting the battery

1. Insert the battery into the battery holder of the Pe-
delec rom the let by tilting it outwards at roughly
45°. In doing so, make sure that the lateral guides at
the bottom of the battery are also inserted into the
guides in the holder.
Reinstalling the battery
2. Tilt the battery towards the bike until it engages in the
locking mechanism. If the key is still in the lock, turn it
clockwise then pull it out to lock the battery in place.
3. Make sure the battery is irmly in place.

5 Control panel and display

5.1

Basic unctions

Control panel
1
2
3
1 Upper arrow button
(more powerul assistance)
2 Set button
3 Lower arrow button
(less powerul assistance)
4 Pushing assistance
5 Power button
• On the let, you will ind the
lower arrow buttons. The buttons have difer-
3
ent unctions depending on the item of the settings
menu at which you are located.
• Between the arrow buttons is the
can be used to request a variety of displays.
4
• The pushing assistance is located at the top
on the right. This moves the Pedelec slowly (at a
maximum speed of 6 km/h) without you having to
turn the pedals.
• The power button is located at the bottom on
5
the right. This can be used to turn the system on
and of again.
VI User Manual | Impulse Ergo Pedelec
4
5
upper and
1
Set button. It
2
17