Switching On/Of; Pushing Assistance - Derby cycle Impuls 2.0 ergo Instrucciones De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 184
Display
2
1
1
Speed
2
Power-assist mode
3
Battery charge state
4
Remaining range indicator
5
Information area
The display in the middle of the handlebar is divided into
ive diferent display panels:
• At the top on the let is your current
• To the right of the current speed is a display show-
ing the selected
2
• At the top on the right is the
which tells you the current charge status of your
Pedelec's battery.
• Below this, in the
you can see the remaining distance over which you
will still receive assistance rom the current bat-
tery charge.
• Along the bottom section of the display is a long
information area that can be used to display the
following information:
How much of its potential output the motor is
currently delivering.
The costs that have been incurred in the course
of the current trip and during the Pedelec's
entire service life.
The saving achieved in both euros and CO
comparison with the same journey by car.
The total number of kilometres covered by this
system.
Display of kilometres covered during the day
and overall.
Display of journey time during the current trip
and the top speed reached on this trip.
The average speed during the current trip and
the total distance covered.
18
VI User Manual | Impulse Ergo Pedelec
3
4
5
 speed.
1
 power-assist mode.
 battery symbol
3
 remaining range indicator,
4

5.1.1 Switching on/of

Press the power button to switch the Impulse system on.
Ater switching on, the system is always in the display
mode in which you switched it of.
If you cannot feel any assistance, simply back-pedal
briely and then pedal forwards again to trigger the
system check. If there is still no assistance being
delivered, the instruction "Please move the pedals"
will continue to be displayed. In this case you should
consult a specialist dealer.
In order to switch your Pedelec of again, press the power
button on the control panel.

5.1.2 Pushing assistance

The pushing assistance moves the Pedelec slowly (at a
maximum speed of 6 km/h) without you having to turn the
pedals, e.g. if you are manoeuvring in a tight space or are
pushing your Pedelec out of a basement garage.
in
2
The pushing assistance is not suitable for use as start-
ing assistance.

Publicidad

Tabla de contenido
loading

Tabla de contenido