Power Tool Use And Care; Service; Safety Instructions For All Applications - Parkside PWBS 180 A1 Traduccion Del Manual De Instrucciones Originale

4. Power tool use and care

a) Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at
the rate for which it was designed.
b) Do not use the power tool if the switch does
not turn it on and off. Any power tool that can-
not be controlled with the switch is dangerous
and must be repaired.
c) Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tool's operation. If damaged, have the
power tool repaired before use. Many acci-
dents are caused by poorly maintained power
tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits,
etc., in accordance with these instructions,
taking into account the working conditions
and the work to be performed.
Use of the power tool for operations different
from those intended could result in a hazardous
situation.
PWBS 180 A1

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
b) Always arrange for the replacement of the
plug or the power cord to be carried out by
the manufacturer of the appliance or by his
approved customer services. This will ensure
that the safety of the power tool is maintained.
Safety instructions for all
applications
General safety instructions for grinding and
sandpaper sanding:
(a) This power tool is intended for use as a grinder
and sandpaper sander. Please follow all safety
instructions, instructions, diagrams and data
that you receive with the appliance.
Failure to observe the following instructions can
lead to an electrical shock, fire and/or serious
injuries.
b) This power tool is not suitable for working with
wire brushes, polishing and cut-off grinding.
Using the power tool for applications for which it
is not designed can lead to hazards and injuries.
c) Do not use any accessories that have not
been specifically provided or recommended
by the manufacturer for this power tool. Just
because you can attach the accessories to your
power tool does not guarantee they are safe to
use.
d) The maximum speed of the accessory tool
used must be at least as high as the maximum
speed specified for the power tool. Accesso-
ries which rotate faster than the maximum per-
missible rate can break and throw pieces into
the air.
GB │ MT │
53 ■