Set-Up Of Operational Parameters; Memorization Of Remote Controls; Deleting Remote Controls - DIMOEL DIMO 700 Manual De Instrucciones

SET-UP OF OPERATIONAL PARAMETERS

MOOV-SEZ50 is equipped
with a practical interface that
allows rapid and simple on-
display programming using
four keys: S, P, +, and -.
Follow the instructions below carefully in order to configure the
parameters correctly.
1. Set-up of opening limit
Press the P key for 5 seconds.
The device will beep and the
display will show 1.
Using the + and - keys, move
the door to the maximum
open position.
Press the P key to memorize
this parameter and proceed to the next. The display will show 2.
2. Set-up of closing limit
Using the + and - keys, move
the door to the maximum
closed position.
Press the P key to memorize
this parameter and proceed
to the next.
The display will show 3.
3. Learning Forces
Press the + key:
the door opens.
When it reaches the limit,
press the - key:
the door closes.
During this phase, the device
will learn all of the force levels necessary to open and close the
door.
Press the P key to memorize this parameter and proceed to the
next. The display will show 4.
4. Adjust the sensitivity
This menu allows the
sensitivity of the device to be
increased or decreased when
the door meets an obstacle.
This parameter is already set
to an average value (4) which
should be optimal for most
installations.
The various levels are shown as follows:
0
-
5. Select the remote control buttons
This menu allows the
selection of the buttons to
control the actuator. This
function can be useful should
it be desirable to control 2
i
actuators using the same
remote control, but with
different buttons.
2
Press the - key to select button 1, the display will
show:
Press the - key to select button 2, the display will
show:
3
Thereafter, to exit the programming, hold the P key pressed for 5
seconds: the display will show
actuator is ready for use.

MEMORIZATION OF REMOTE CONTROLS

1. Press key S until the dot
appears on the display.
2. Release key S and press
the remote control button
twice: the device emits a
BEEP and the dot is
4
turned off to confirm
storage in the memory has
occurred
3. Repeat the procedure for the other remote controls to be
memorized.

DELETING REMOTE CONTROLS

1. Press and hold key S: after approx. 1 second the dot appears
on the display.
2. Hold the key until the dot on the display is turned off: the
remote controls have been deleted.
15
0 0 0
1 2 3
0
0 0 0
4 5 6
5
8
8
and will go into standby. The
0
+