NuWave OxyPure Manual Del Usuario página 20

CARE & MAINTENANCE (Continued)
Cleaning the Filters
To clean the Bio-Guard
Remove filter.
1.
Spray mild degreaser, let sit for 2-3 minutes.
2.
Submerge in warm water, shake, remove.
3.
Repeat process until clean.
4.
Rinse with warm water.
5.
Dry completely before use.
6.
The Pre-Filter collects large particles and will need to be cleaned at least
once every two months depending on use.
Use a vacuum or paper towel to remove any dust or lint.
1.
Clean with warm soapy water.
2.
Rinse thoroughly and remove any soap particles on the filter.
3.
Allow filter to dry completely BEFORE placing back into OxyPure
4.
(up to 12-24 hours to dry).
Resetting the Filter and Air Quality Indicators
To reset the Air Quality Indicator for AIR, press and hold down "TIMER" for 2
1.
seconds until a beep is heard.
After a filter is cleaned or replaced and indicator is reset, the first green
•
bar around AIR will be lit.
To reset the Air Quality Indicator for ODOR, press and hold down "TURBO"
2.
for 2 seconds until a beep is heard.
After a filter is cleaned or replaced and indicator is reset, the first green
•
bar around ODOR will be lit.
20
Owner's Manual
HEPA/Activated
Carbon Combo Filter
Ozone Emission Removal Filter
Bio-Guard
Filter:
™
Filter
™
Stainless Steel Pre-Filter