auna Bebop Manual Del Usuario página 13

On/Standby
Input source
EQ
Echo effect
Lautstärke
DSP
Balance
Music control
NumPad / Mem
Radio controls
Reset
• Use a) BT on the RC or b) press and hold MENU on the control panel or c) use INPUT to set the device
into BT pairing mode.
• The device will look for the last connected BT device and will automatically connect if available and
within range (BT LED flashes slowly).
• If no formerly connected device can be found, after 15 seconds the pairing mode will be enabled (BT
LED flashes fast).
• You now can connect your BT device (smart phone, tablet etc...) with the BEBOP.
Select input source (AUX, CD, BT, LINE, USB, FM);
Disconnect BT (BT QUIT);
Set bass- (BASS +/-) and treble (TREBLE +/-);
Set echo effect volume (ECHO +/-);
Set overall volume (VOL +/-);
Set the mic level (MIC +/-);
Mute / un-mute (MUTE);
Set the level of DSP within the overall sound (DSP +/-)
Adjust stereo balance (L / Balance / R)
Music control ( /
Reset USB thumb drive playback (USB-RESET);
Selebct repeat modes (REPEAT);
Select desired track directly;
Press MEM and then any number to save currently playing radio station to cor-
responding preset memory. Please note that any formerly stored stations will be
overwritten.
Tune up/down (TUNE +/-);
Next/previos preset (CH +/-);
Select stereo or mono sound (ST/MO);
Automatic station scan (FM AUTO SCAN);
Reset (RESET)
BT Pairing / Operation
/ );
13