GHP Group Pleasant Hearth OFG467T Manual De Instrucciones página 12

ASSEMBLY INSTRUCTIONS
7. Hold the burner assembly (J) over the square hole
of the table (C). The valve stem should face the
left side panel (G) and should go through the hole
on the left side panel (G) as the burner assembly
(J) is placed into the table (C). Attach the burner
assembly (J) to the table (C) with four M5X8
screws (BB). Tighten with screwdriver (GG).
Hardware Used
BB
Screw M5 x 8
GG
Phillips screwdriver
8. Attach the control knob (L) onto the valve stem as
illustrated in figure 8. Turn the control knob ( L ) to
the "OFF" (o) position as illustrated
9. Pour one pack of glass rocks (I) over the burner.
Do NOT cover ignition screen (P) with glass rocks.
Use a glove when handling glass rocks.
WARNING
DO NOT COVER THE IGNITION SCREEN when
placing the glass rocks into the fire bowl. Always
keep Ignition Screen visible. This screen must be
clear and free of obstructions at all times to insure
proper operation.
Screen
Do not place
glass rocks on screen.
Keep screen clear.
The burner of the firebowl must be covered by glass rocks
completely. Otherwise the flame may be extinguished occasionally.
See the Figure CORRECT and INCORRECT for reference.
CAUTION
GLASS ROCKS - Use a glove when handling glass rocks.
1. Do not light or use gas unit if glass rocks are wet. Make sure glass
rocks are completely dry before lighting as intense heat could cause
the rock to crack.
2. Glass rocks could hit a person's face or eyes during the initial startup
of this unit. Keep away from the appliance for the first 20 minutes after
lighting.
3. Use only Pleasant Hearth / GHP Group, Inc. factory-authorized glass
rocks. The use of any glass rock that is not factory-authorized can be
dangerous and will void your warranty.
Figure a Figure b Figure c
7
X 4
8
in.
in.
in.
Normal
CORRECT
9
INCORRECT
12
C
G
in.
in.
in.
Abnormal
L
P
I
CC
J