Brake Pedal; Side View; Front View - Chevrolet LT1 E-ROD Hoja De Instrucciones

Lower exhaust manifold heat shields
Lower exhaust heat shields can be purchased for your installation. Please reference a 2017 Camaro or later model year with a LT1 engine for correct part
numbers.
LOWER EXHAUST
MANIFOLD HEAT SHIELDS
ECM
The Engine Control Module (ECM) is environmentally sealed and can be mounted under hood, however, avoid extremely hot locations (exhaust, etc.) or
high splash areas. It is not recommended that the ECM be mounted directly to the engine.
Accelerator Pedal
Mount the accelerator pedal per the following dimensional guidelines, mounting details are application-specific and are left to the user. Ensure that the
pedal is securely mounted to the vehicle. A grommet is required in any sheet metal hole that the harness routes through to avoid wire damage.

BRAKE PEDAL

ACCELERATOR
PEDAL

SIDE VIEW

Mass Air Flow (MAF) Sensor
NOTE: It is critical that the MAF sensor is mounted per the instructions below. Vehicle performance and/or drivability
may be affected if it is not mounted as recommended.
The mass air flow sensor must be installed in the induction system using the supplied MAF sensor mounting boss. The induction system should be 4
inches in diameter and have a minimum straight section 6 inches in length. Mount the MAF sensor in the middle of the straight induction section,
ensuring that the middle of the mounting boss is at least 10 inches from the throttle body.
The MAF sensor must be oriented correctly in the induction system - note the arrow on the sensor indicating flow
direction. Be sure to weld the mounting boss correctly - the sensor will only mount one way in the boss (see diagram).
THE MAF MAY NOT HAVE A FLOW DIRECTION ARROW ON THE TOP. THE CORRECT ORIENTATION OF THE MAF IS AS SHOWN BELOW:
LT1 E-ROD Instruction Sheet
ALL INFORMATION WITHIN ABOVE
Date
BORDER TO BE PRINTED EXACTLY
20MY19
AS SHOWN ON 8.5 x 11 WHITE 16
POUND NON-BOND RECYCLABLE
03OC19
PAPER. PRINT ON BOTH SIDES,
EXCLUDING TEMPLATES. TO BE
UNITIZED IN ACCORDANCE WITH
GMCCA SPECIFICATIONS.
BRAKE
PEDAL
ACCELERATOR
PEDAL
Rev 03OC19
Revision Auth
Init Rel – Blake Nye
NA
Rev – Blake Nye
NA
TUNNER/
CONSOLE

FRONT VIEW

PART No.
19418603
DR
Installation Instructions
Title
19418603
PART No.
SHEET
11 of 69
LT1 E-ROD
SHEET 11 of 69