Determining Minimum I.d. Of Furniture - CHIEF CM2L40 Instrucciones De Instalación

CM2L40
NOTE:
With the mount configured for the display and the
display installed, it is now possible to calculate the
minimum I.D of the cabinet.

Determining Minimum I.D. of Furniture

1. Measure and record distance "A". (See Figure 16)
2. Measure and record distance "B". This is the material
thickness of the cover that will be mounted to the CM2. (See
Figure 16)
3. Add measurements from Steps 1 and 2 together. The total
is the minimum inside height of the furniture.
4. Measure and record distance "C". This dimension is from
the back side of the CM2 vertical mounting bracket to the
furthest point forward on the display. (See Figure 16)
CAUTION:
IMPROPER FIT TOLERANCES CAN CAUSE
AREAS OF MOUNT OR FURNITURE TO COLLIDE WHEN
OPERATING THE MOUNT CAUSING SERIOUS DAMAGE
TO EQUIPMENT! Always provide for adequate tolerances
when building cabinet especially between base and cover.
(See Figure 15)
10
Cover
Base
WARNING:
EXCEEDING STATED WEIGHT LIMITS OF
THE CM2 CAN LEAD TO SERIOUS PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! The weight of furniture cover
must be calculated into the total weight being placed on the
mount; a total not to exceed 190 lbs (86.18 kg) the maximum
capacity of the CM2.
C
B
A
Figure 16
Installation Instructions
Figure 15
C