CM2L40
Mount Installation
The CM2 has been designed to be mounted into a cabinet or
similar type of furnishing.
The following installation instructions assume a suitable
structure and surface exists prior to installation.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installers responsibility
to make certain the structure to which the lift is being
mounted is capable of supporting 4 times the weight of the lift
and all attached equipment.
IMPORTANT ! :
The finished furniture with display on and
mount fully raised must be able to be placed at a 10° angle front
and back without tipping.
To install the CM2:
1.
If the display is installed and cables routed, disconnect
wires and cables from display, uninstall top shelf and
display.
2.
Remove mount from wooden supports used during mount
setup and configuration.
WARNING:
MOUNT WEIGHS IN EXCESS OF 40LBS!
Always use two people and proper lifting techniques when
installing or positioning mount.
3.
Determine base position within furnishing framework.
4.
Position mount until base is properly positioned and side
mounting brackets are in line with vertical supports.
(See Figure 23)
5.
Loosen four screws securing side mounting brackets to
mount and adjust side mounting brackets until properly
positioned against vertical mounting surface.
(See Figure 24)
6.
Tighten four screws to hold position of side mounting
brackets. (See Figure 24)
5
x 4
x 4
6
Figure 23
14
7.
Mark eight base mounting hole locations. (See Figure 24)
8.
Drill pilot holes at marked locations.
9.
Mark four side bracket mounting hole locations.
(See Figure )
10. Drill four pilot holes at marked locations.
11. Secure mount base to mounting surface using eight screws.
(See Figure 24)
12. Secure mount to vertical mounting surface using four
screws. (See Figure 24)
12
11
13. Install display following the procedures outlined in Display
Installation section.
3
Installation Instructions
x 4
9
x 4
10
8
7
Figure 24
x 8
x 8