Specifications; Radio Interference - Arcam FMJ D33 Manual

specifications

Analogue Audio Output
Digital to Analogue conversion 2x Burr Brown 24-bit 192kHz Advanced Segment Delta-Sigma DAC ICs
Signal to noise ratio 110dB CCIR
Harmonic distortion (1kHz) 0.0008% (20Hz — 20kHz, unweighted)
Frequency response (+0.1dB, -0.5dB) 10Hz–20kHz
Output level (0dB) 2.2Vrms
Output impedance 47
Ω
Minimum recommended load 5k
Ω
Digital interfaces
USB Class 1 electrically-isolated USB 1.1
Class 2 USB 2.0 High Speed (480 Mbit/s)
AES/EBU Up to 192kHz sample rate
Coaxial S/PDIF x 2 Up to 192kHz sample rate
Optical S/PDIF (TOSLINK) x 2 Up to 96kHz sample rate
Physical
Dimensions W433 x D370 x H110mm
Weight 6.2kg nett/10.0kg packed
Power consumption 30W maximum
Analogue output connection RCA Phono x 2
Balanced XLR
Supplied accessories
Mains lead
CR107 remote control
2 x AAA batteries
E&OE
NOTE: All specification values are typical unless otherwise stated
E-12

Radio interference

The D33 DAC is a digital device which has been
designed to very high standards of electromagnetic
compatibility.
All DACs generate, and can radiate RF (radio frequency)
energy. In some cases this can cause interference with
FM and AM radio reception. If this is the case, keep the
DAC and its connecting cables as far from the tuner
and its aerials as possible. Connecting the DAC and the
tuner to different mains sockets can also help to reduce
interference.
EC COUNTRIES – This products have been designed to
comply with EMC Directive 2004/108/EC.
USA – These products comply with FCC Part 15
Class B.
Continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.