Angle Adjustable Locking Flip Up Extendable Armrest - Ki Mobility Catalyst 5 Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
E. Angle Adjustable Locking Flip Up Extendable Armrest
Adjustments
1. Set the angle of the armrest based on your preferences. There are five holes that can be used
to set the angle (Fig. 4:A). Tighten the bolt once angle is set.
2. Set the length of the armrest based on your preferences. To adjust the length, remove the
bolts and spacer (Fig. 4:B) on the tube and the screw (Fig. 4:C) closest to the back of the
chair. Slide the armrest to desired length available by the predrilled holes and reinstall the
screw and bolts.
3. Set the height of the armrest on the chair based on your preferences. There are four holes on
the armrest that allow for two different height settings for each set of holes on the back tube.
Use the holes that provide the correct height setting for the user. The two bolts (Fig. 4:D) pass
through the spacer (Fig. 4:E), sleeves (Fig. 4:F), back posts and into the armrest.
Use
1. Press the release lever (Fig. 4:G) up to release the armrest and swing it upwards.To return the
armrest to the operating position, push the armrest down until the lever clicks and locks.
Fig. 4
A
DANGER: Always make sure the arms are locked in place before using them for repositioning
yourself, failure to do so may result in a fall or loss of control and may cause serious injury or
death.
DANGER: Never attempt to lift the chair by the armrests; they may break or disconnect resulting
in a fall or loss of control and may cause serious injury or death.
F
G
B
19
D
E
C