ION Tiki Sounds Guia De Incio Rapido página 4

Setup
1. Make sure all items listed in the
sold separately.
2. Read the Safety & Warranty Manual before using the product.
3. Make sure the battery is completely charged prior to first use for maximum battery life.
Assembly
Tiki Sounds may be used mounted using the included post; freestanding using the included
base; or hanging using the included handle. Follow the instructions below for how you would
like to use Tiki Sounds.
Important: If using the solar panel to prolong battery life between charges, make sure to place
Tiki Sounds in an area that receives at least 3 hours of direct sunlight a day for best results.
For fastest charging, power off Tiki Sounds and connect to USB.
Pole Mounted
1. Drive the ground stake into the ground where you would like to install Tiki Sounds.
Important: If the ground where you would like to install Tiki Sounds is hard or tough, use a
shovel to loosen the soil prior to driving the ground stake.
2. Attach the three sections of the extension tube to the ground stake. The middle section is
tapered at both ends to connect to the other sections, and the top section includes a cap
used to secure Tiki Sounds and prevent water from entering the pole.
3. Place Tiki Sounds so that the hole at the bottom of the speaker is in line with the cap at
top of the pole mount. Gently push Tiki Sounds onto the pole mount until it is secure.
4. Before attempting to move Tiki Sounds, always remove the speaker from the pole mount
first. Hold the topmost section of the pole with one hand and gently pull Tiki Sounds up
until it is separated from the pole mount.
Freestanding
1. Place the lamp base on a flat, stable surface.
Note: If desired, a screw can be inserted into the center of the lamp base to secure the
speaker in place.
2. Place Tiki Sounds on the lamp base so that the hole at the bottom of the speaker is in line
with the post at the top of the base. Gently push Tiki Sounds onto the base until it is
secure.
3. To remove Tiki Sounds from the base, hold the base with one hand and gently pull Tiki
Sounds up until it is separated from the base.
Hanging
1. Attach the included handle to the holes located on the outer edge of each Tiki Sounds
speaker. Make sure the handle "snaps" into place to indicate it is properly secured before
attempting to hang Tiki Sounds.
2. To remove the handles, gently pull each side away from the speaker until it is separated.
4
Box Contents are included in the box. Items not listed are