Introduction; Proper Use; Delivery Contents; Component Description - ULTIMATE SPEED ULG 3.8 A1 Instrucciones De Utilización Y De Seguridad

Introduction

the following pictograms are used in these operating instructions / on the device:
Read instruction manual!
Observe caution and safety notes!
Caution – electric shock!
Danger to life!
Risk of explosion!
Risk of fire!
W
Watts (Effective power)
Car battery charger ULG 3.8 A1
Introduction
Q
P lease carefully read these operating
instructions and fold out the page with
the illustrations. Keep these operating
instructions in a safe place and hand them over to
anyone to whom you pass on the appliance.

Proper Use

Q
The ULtIMAtE SPEED ULG 3.8 A1 is a battery
charger with a pulse trickle charge mode and is
suitable for charging and maintenance charging of
the following 6 V or 12 V lead rechargeable batter-
ies with wet cell or gel electrolyte:
• 6 V: with a capacity of 1.2 Ah to 14 Ah
• 12 V: with a capacity of 1.2 Ah to 14 Ah
• 12 V: with a capacity of 14 Ah to 120 Ah
You can also used it to regenerate completely dis-
charged batteries. The battery charger has protective
circuits to prevent sparking and overheating. Any in-
correct or improper use leads to loss of the warranty.
The manufacturer takes no responsibility for damage(s)
arising out of usage that is contrary to the instructions
26 GB
V ~
Volt (AC)
Safety class II
For indoor use only!
Keep children away from
electrical devices!
Check that the device, mains lead
and plug are in good condition!
laid down. The appliance is not meant for commer-
cial use.

Delivery Contents

Q
Check the appliance and all accessories for damage
immediately after unpacking. Do not put a defective
appliance or parts into operation.
1 Charger ULtIMAtE SPEED ULG 3.8 A1
2 Quick / contact clamps (1 red, 1 black)
1 Operating manual

Component description

Q
see Fig. A:
LED display (standby)
1
„6 V" LED display „Mode 1"
2
LED display „Mode 2"
3
LED display „Mode 3"
4
LED display „Mode 4"
5
LED display „incorrect polarity / fault"
6
LED display „fully charged"
7
LED display „Charging process active"
8
Q
Selection button „MODE"
9