Installation Instructions - RIDGID WD16400 Manual Del Proprietário

Maintenance (continued)
Filter Bag

INSTALLATION INSTRUCTIONS

A filter bag may be used in place of or in
addition to the Qwik Lock™ cartridge
filter.
NOTE: When picking up dry debris a filter
bag or cartridge filter must be properly
installed.
1. Filter bag to be used to pick up dry
debris only.
2. Correct positioning of cardboard collar
is required to assure proper seal.
3. Locate two ribs on inlet tube, inside
drum.
4. Slide cardboard collar onto inlet tube
and position cardboard collar between
the two ribs.
5. With the cardboard collar securely
installed, unfold and position filter bag
inside drum, as shown.
REMOVAL INSTRUCTIONS
1. Slide cardboard collar toward center of
Vac drum.
2. Remove filter bag from Vac drum and
discard.
3. Install new filter bag.
WARNING: To avoid health
hazards from vapors or dust, do not
vacuum toxic, carcinogenic or other
hazardous materials such as
asbestos, arsenic, barium,
beryllium, lead, pesticides or other
health endangering materials.
CAUTION: To avoid spilled
debris, when picking up heavy or
sharp material, monitor bag volume
and do not overfill.
Ribs (2)
Inlet Tube
12
Filter Bag
Cardboard
Collar
Vac
Vac
Unfolded
Filter Bag
Cardboard
Collar