General Electric PBM21 Instructivo Y Advertencias página 66

Installation
Instructions
IMPORTANT NOTES
When reversing Doors:
Read the instructions all the way through before starting.
Logo badge and handles are included inside the Refrigerator.
Set screws down by their related parts to avoid using them in
the wrong places.
Provide a non-scrathcing work Surface for the doors.
IMPORTANT:
Once you begin, do not move the cabinet until
door reversal is completed.
These instructions are for changing the hinges from the right side
to the opposite side. If you ever want to change the hinges back
to the right side, follow these same instructions and reverse all
references to left and right.
CAUTION
Lifting Hazard. Single person lift could cause injury. Use assistance
when handling, moving or lifting the refrigerator doors.
Note: When removing door, to prevent damage to door and
electronics, carefully place the door in a proper location.
Note: The lower door hinge pin and hinge are keyed and must be
matched correctly for the door to self close properly. Please follow
the directions carefully.
Freezer door is heavy, use both hands to secure the door before lifting.
! WARNING
To eliminate the risk of electric shock
or injury during installation, you must
first unplug the refrigerator before
proceeding. Failure to follow these
instructions can result in electrical
shock.
TOOLS YOU WILL NEED
5/16"
Socket Ratchet/ Driver
Thin-blade Screwdriver
1/4" Allen Wrench
or Screwdriver
Torx T-20 Driver
Phillips Screwdriver
Adhesive Tape
66
Reversing Doors
1 REMOVE THE REFRIGERATOR DOOR
1.1 Tape the door shut
with adhesive tape.
1.2 Remove right and left hinges cover on top the refrigerator
using a Phillips screwdriver.
1.3 Using a 5/16" Socket ratcher/driver, remove the bolts securing
the top hinge to the cabinet. Then lift the hinge straight up
to free the hinge pin from the socket in the top of the door.
1.2
COVERS HINGE
1.4 Remove the tape and tilt the door
away from the cabinet.
Lift the door of the center
hinge pin.
1.5 Set the door on a non-scratching
surface with the inside up.
2 REMOVE CENTER HINGE
(For models without freezer door)
2.1 Using a 1/4" Allen screwdriver
remove the hinge pin from
the hinge bracket, the hinge
pin will be used again on the
opposite side.
1.3
TOP HINGE